This Mono Amplifier Circuit is Super Easy To Build

This is the easiest mono amplifier circuit to build, as far as I know.

I love it because it is powerful enough to play pretty loud. And it doesn’t need a pre-amp, heat-sink or any weird transistors.

All it requires, is a few standard capacitors, a couple of resistors and a potentiometer.

It will give you 4.7 Watts of power. This should be enough to play music in the park with some friends and a couple of brewskies.

I’ve added the schematics, PCB design and Gerber files a little further down the page.

It’s also possible to make a stereo amplifier circuit, with some small changes to the circuit.

Mono Amplifier Circuit Diagram

Build Something Useful This Evening

This gadget lets you use any IR remote-control to control your lamp, garden lights, heater oven, garage door, or anything else.

Download Build Instructions

Parts list:

PS! There are no C1, C2 or C10. The reason for this is just that I added and deleted some capacitors in the schematics, and forgot to rearrange the numbers.

Part	Value	Description
C3	100µF	POLARIZED CAPACITOR
C4	100µF	POLARIZED CAPACITOR
C5	100µF	POLARIZED CAPACITOR
C6	100µF	POLARIZED CAPACITOR
C7	100µF	POLARIZED CAPACITOR
C8	100µF	POLARIZED CAPACITOR
C9	0.22µF	NON-POLARIZED CAPACITOR
C11	0.15µF	NON-POLARIZED CAPACITOR
C12	0.15µF	NON-POLARIZED CAPACITOR
TEA2025	TEA2025B	Amplifier chip
SPKR		4-8 Ohm speaker
R1	1K	Resistor
R2	1K	Resistor
R3	10K	Logarithmic Potentiometer

How To Build It

You can build the mono amplifier circuit on an experiment board. Such as a stripboard. It’s simple enough to do that. And you can use only through-hole components.

Or you can design your own printed circuit board. This is a good idea if you want to create several mono amplifier circuits. Or if you just want to practice your PCB design skills.

Either way, you have to make sure you place the capacitors the correct way. In this circuit, we use polarized capacitors. Polarized capacitors have a plus-side and a minus-side. They must be placed accordingly.

There are a few non-polarized capacitors too. You can place these whichever way you want.

Power the circuit with 3 to 12 volts. But, you need 12 volts if you want to get full power out of it.

And if you are a bit lazy – here you go:

Download Eagle schematics, PCB design and Gerber files

The TEA2025 Amplifier Chip

The thing that makes it possible to create a mono amplifier circuit so easily, is the TEA2025 chip. As far as I have seen, it’s one of the simplest chips to use.

It is an old chip, so it might not be available for too long. The old and cool chips have a tendency to go out of production at some stage.

But at the time of writing (February 2015), I can see that it’s available in several online stores.

You can use www.findchips.com to – you guessed it – find chips ;)

Return from Mono Amplifier Circuit to Circuit Ideas

More Circuits & Projects Tutorials